How to Do Garage Door Replacement Properly


Doing garage door replacement on your own? View this helpful article to assembly the pieces together properly

Garage door replacement isn’t as hard as it might be; you only need to follow this instruction properly in order to be able to replace your garage door safely, accurately and properly. Replacement usually occurs when the old garage door is no longer working compatibly and might harm someone’s safety or things like that. However, replacing your garage door requires steps by steps guide to make it easier for you to understand, that’s why here, you will find exactly what you need.

Garage Door Replacement—This is What You Should Do

The first thing you should do is measure the door right. There is no way you buy a new garage door without knowing the measurements of the old garage, right? That’s the reason why this is the basic knowledge and also the most important thing to do in replacing garage door. Measure the width of the door from the actual structural member, not the trim piece. But the measurement doesn’t stop there, it continues to the next step: measure for head room in order to give enough space for the door to move when it’s operating. Therefore, you also need to lower the door. This is aimed to make sure there are no such things as pipes or framing members in the way.

The next step you want to do is removing all the old parts, including all the old panels and the old assembly and the old operator. Then, when it’s cleaned for the new door to be installed, prepare the frame. Remove the header trim and the old 2″ x 4″s so the rough opening can be reframed. Use new 2″ x 4″s for this and attach them with 16-penny nails. Once the reframing step has finished, it’s time to level the new door in order for it to fit.

The bottom panel needs to be trimmed properly; use compass if it needs to make sure it conforms to the concrete floor. Then, it’s time to install the spring. Weather spring is an important element in garage door replacing process too, although it wears out over time and one time it’ll need to be changed. Lastly, attach the other entire element left like corner brackets, hinges, tracks and rollers. After they’re installed, fasten them and install the operator support. Before you completely finish the replacement, you need to install the trim using a paint scrapper and then to finish it off, paint the door. No rush in doing garage door replacement. Make sure you install it right and proper.