Have you heard the term of pedestal sink? If you have not known yet, please give your good attention to this great review of it! Well, a pedestal sink is one of the bathroom sink kinds. In a fact, it is usually used in many standard houses.
In installing the pedestal sink, it is important for you to provide some tools and materials. For the tools which are needed, you can provide them. They are a socket wrench; slip joint pliers, a level, tape measure, adjustable wrench, a pipe wrench, a drill, square, and a pencil. Then, for the materials, you should prepare a sink, faucet, a plumber’s putty, drain assemblies, and a Teflon tape.
In addition, those tools and materials above are so significant and required during the process of setting up a pedestal sink. Hence, you have to complete both requirements in order to have this kind of sink perfectly.
How to install a pedestal sink easily
Talking about the ways of installing a pedestal sink, you need to know that there are some easy ways that you can do. Follow them carefully!
- Take the old sink away
The first step that you have to do is turning off the water which at the most important pipe. After that, you are able to install a heater of the water. Even though the water is stopped when it is turning off, there is still some water which is left on the faucet. In order to solve this problem, you are suggested to open the faucet. Actually, it is used to let the water go and of course, drain the sink too. Thus, the old sink could be removed in a safe way.
- Put the new sink
Before placing the new sink, you should take the old supply stops away using two adjustable wrenches. Then, place the new ones and tighten them again using those tools. So, you are able to set the sink location using the lavatory.
Moreover, the location of the sink should be in the middle of the drain hole which is on the wall. The next step is marking the area and the holes would be drilled using a pencil. Finally, before putting the new pedestal sink, you are allowed to install the lag screws behind the wall.
- Mount the sink to the floor
In this case, it is important for you to mount the sink to the floor. It can be done by using a drill and also screws. It is done in order to get a stabilization of the sink. After that, you need to gather the whole sink’s hardware. Surely, it is placed at the right one.
Besides, you can add some plumber’s putty around the base of the sink. Then, don’t forget to tighten them using the screws. Hence, you are able to install the P-trap correctly and just try your new pedestal sink! If there is still any leakage or like damage in your new sink, you are very suggested to fix it as soon as possible. It is so important for you guys. Apply it well!